Home › TRANSMISSION ยท U660E AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE COOL AIR INTAKE DUCT SEAL


    A132967
  1. Remove the 7 clips and intake duct seal.



3. REMOVE AIR CLEANER INLET ASSEMBLY


    A132969
  1. Remove the 2 bolts, clamp and air cleaner inlet.



4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A135704
  1. Disconnect the 3 vacuum hoses.



    A135705E01
  1. Disconnect the mass air flow meter connector (*1).

  1. Disconnect the No. 2 ventilation hose (*2).

  1. Disconnect the hose band (*3).



    A135706
  1. Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.



5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A132971
  1. Disconnect the vacuum hose and hose clamp.

  1. Remove the 3 bolts and air cleaner case.



6. REMOVE NO. 1 AIR CLEANER INLET


    A132970
  1. Remove the bolt and No. 1 air cleaner inlet.



7. REMOVE AIR CLEANER BRACKET


    C132235
  1. Separate the wire harness clamp.

  1. Remove the 3 bolts and air cleaner bracket.



8. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C132237
  1. Remove the clip from the transmission cable bracket.



    C132236
  1. Remove the nut and transmission control cable from the control shaft lever.

  1. Disconnect the connector from the park/neutral position switch.



    C136685
  1. Remove the nut, washer and control shaft lever from the control shaft.



    C135732
  1. Remove the 2 bolts and park/neutral position switch from the control shaft.

    NOTICE:
    Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral switch cannot be reinstalled correctly.