PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and intake duct seal.
| 3. REMOVE AIR CLEANER INLET ASSEMBLY |
![]() |
Remove the 2 bolts, clamp and air cleaner inlet.
| 4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the 3 vacuum hoses.
![]() |
Disconnect the mass air flow meter connector (*1).
Disconnect the No. 2 ventilation hose (*2).
Disconnect the hose band (*3).
![]() |
Disconnect the 3 bands, and remove the air cleaner cap sub-assembly.
| 5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the vacuum hose and hose clamp.
Remove the 3 bolts and air cleaner case.
| 6. REMOVE NO. 1 AIR CLEANER INLET |
![]() |
Remove the bolt and No. 1 air cleaner inlet.
| 7. REMOVE AIR CLEANER BRACKET |
![]() |
Separate the wire harness clamp.
Remove the 3 bolts and air cleaner bracket.
| 8. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Remove the clip from the transmission cable bracket.
![]() |
Remove the nut and transmission control cable from the control shaft lever.
Disconnect the connector from the park/neutral position switch.
![]() |
Remove the nut, washer and control shaft lever from the control shaft.
![]() |
Remove the 2 bolts and park/neutral position switch from the control shaft.