DIFFERENTIAL OIL SEAL > REMOVAL |
| 1. DRAIN AUTOMATIC TRANSAXLE FLUID |
Using a 6 mm socket hexagon wrench, remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 2. REMOVE FRONT WHEEL |
| 3. REMOVE FRONT AXLE HUB NUT LH |
![]() |
Using SST and a hammer, release the staked part of the front axle hub nut.
While applying the brakes, remove the front axle hub nut.
| 4. REMOVE FRONT AXLE HUB NUT RH |
| 5. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Remove the nut and separate the front stabilizer link assembly.
| 6. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH |
| 7. SEPARATE FRONT SPEED SENSOR LH |
![]() |
Remove the bolt and clip, and separate the speed sensor wire and flexible hose from the shock absorber.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 8. SEPARATE FRONT SPEED SENSOR RH |
| 9. SEPARATE TIE ROD ASSEMBLY LH |
![]() |
Remove the cotter pin and nut.
Using SST, separate the tie rod end sub-assembly from the steering knuckle.
| 10. SEPARATE TIE ROD ASSEMBLY RH |
| 11. SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM LH |
![]() |
Remove the bolt and 2 nuts, and separate the front suspension lower No. 1 arm from the lower ball joint.
| 12. SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM RH |
| 13. SEPARATE FRONT AXLE ASSEMBLY LH |
![]() |
Put matchmarks on the front drive shaft assembly and the axle hub.
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
| 14. SEPARATE FRONT AXLE ASSEMBLY RH |
| 15. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the front drive shaft assembly LH.
| 16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Using a screwdriver, remove the bearing bracket hole snap ring.
Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
| 17. SECURE FRONT AXLE ASSEMBLY LH |
![]() |
Secure the front axle hub bearing.
| 18. SECURE FRONT AXLE ASSEMBLY RH |
| 19. REMOVE TRANSAXLE HOUSING OIL SEAL |
![]() |
Using SST, pull out the oil seal.
| 20. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL |
![]() |
Using SST, pull out the oil seal.