Home › TRANSMISSION ยท U660E AUTOMATIC TRANSAXLE › SHIFT LEVER

SHIFT LEVER > ADJUSTMENT

for Preparation Click here



1. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to the N position.



    C132236
  1. Remove the nut and transmission control cable from the control shaft lever.



    C135733E03
  1. Align the protrusions of the park/neutral position switch.



    C135734E02
  1. Move the slider in the directions indicated by the arrows and pull up the lock piece.

    NOTICE:
    Do not damage the boot.



    C132236
  1. Connect the transmission control cable assembly to the control shaft lever with the nut.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    C138300E01
  1. Push in the lock piece.

    NOTICE:
    Firmly push in the lock piece until the slider lock is engaged.

  1. Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position.
    If it becomes hard to move the shift lever, readjust the shift lever position.