Home › BODY ELECTRICAL › HORN › HORN RELAY

HORN RELAY > INSPECTION

for Preparation Click here



1. INSPECT FUSE (HORN)
  1. Check the resistance of the HORN fuse.

    Standard:
    Below 1 Ω



2. INSPECT HORN RELAY
  1. Remove the engine room R/B and J/B (horn relay).



  1. Measure the resistance according to the value(s) in the table below.


    B131164E01

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1G-1 - 1B-6
    When battery voltage is not applied to terminals 1D-1 and 1D-10
    10 kΩ or higher
    1G-1 - 1B-6
    When battery voltage is applied to terminals 1G-1 and 1D-10
    Below 1 Ω