AUTOMATIC LIGHT CONTROL SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR |
![]() |
Disconnect the E11 automatic light control sensor connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E11-6 (CLTB) - E11-3 (CLTE) | Ignition switch OFF | Below 1 V |
| Ignition switch ON | 10 to 14 V |
| Tester Connection | Specified Condition |
| E11-3 (CLTE) - Body ground | Below 1 Ω |
Reconnect the automatic light control sensor connector.
Connect an oscilloscope to the automatic light control sensor connector.
![]() |
Check the waveform.
| Tester Connection | Tool Setting | Condition | Specified Condition |
| E11-3 (CLTE) - E11-5 (CLTS) | 5 V/DIV., 5 ms./DIV | Ignition switch ON, light control switch in AUTO | Correct waveform is as shown |