Home › BODY ELECTRICAL › LIGHTING › BACK-UP LIGHT SWITCH

BACK-UP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK-UP LIGHT SWITCH (for Manual Transmission)


    B113725E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Operation
    Specified Condition
    1 - 2
    Switch ON
    (Ball is not pressed)
    10 kΩ or higher
    1 - 2
    Switch OFF
    (Ball is pressed)
    Below 1 Ω

    If the result is not as specified, replace the back-up light switch.