Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR


    A095434E01
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    Make sure that the O-ring is not cracked or jammed when installing it.



    A124557
  1. Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Connect the sensor connector.



2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner filter element onto the air cleaner case.



    A135670
  1. Insert the hinges. Install the air cleaner cap sub-assembly with the 2 bolts.



    A135671E01
  1. Align the matchmarks of the No. 1 air cleaner hose and throttle body, and then connect the air cleaner hose No. 1 to the throttle body and unfasten the No. 1 air cleaner hose clamp.

    NOTICE:
    Make sure that the hose clamp is at the correct angle.



    A135667E01
  1. Connect the No. 2 ventilation hose to the air cleaner hose.



    A135666E02
  1. Connect the purge line hose to the clamp (*1).

  1. Connect the 2 purge VSV vacuum hoses (*2).

  1. Connect the purge VSV connector (*3).

  1. Connect the mass air flow meter connector (*4).



3. CHECK FOR ENGINE OIL LEAKS


4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    A134904
  1. Install the engine cover with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }