Home › ENGINE · 2AZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT POSITION SENSOR


    A095265E01
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 (G+) - 2 (G-)
    835 to 1,400 Ω at Cold
    1 (G+) - 2 (G-)
    1,060 to 1,645 Ω at Hot

    NOTICE:
    "Cold" and "Hot" mean the temperature of the coils themselves. "Cold" is from -10 to 50°C (14 to 122°F) and "Hot" is from 50 to 100°C (122 to 212°F).

    If the result is not as specified, replace the camshaft position sensor.