CAMSHAFT POSITION SENSOR > REMOVAL |
| 1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and cover.
| 2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the mass air flow meter connector (*1).
Disconnect the purge VSV connector (*2).
Disconnect the 2 purge VSV vacuum hoses (*3).
Disconnect the purge line hose from the clamp (*4).
![]() |
Disconnect the No. 2 ventilation hose from the air cleaner hose.
![]() |
Lock the No. 1 air cleaner hose clamp, and then disconnect the No. 1 air cleaner hose from the throttle body.
![]() |
Remove the 2 bolts and air cleaner cap.
Remove the air cleaner filter element from the air cleaner case.
| 3. REMOVE CAMSHAFT POSITION SENSOR |
![]() |
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor.