Home › ENGINE ยท 2AZ-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR CLUTCH PULLEY


    A126771
  1. Using a screwdriver, puncture the center of the generator pulley cap and pry it off.

    NOTICE:
    Do not reuse the generator pulley cap.



    A124115E01
  1. Set SST (A) and (B).

    SST
    09820-63020  

  1. Clamp SST (A) in a vise.



    A128605E01
  1. Place the rotor shaft end into SST (A).



    A128606E01
  1. Fit SST (B) to the clutch pulley.



    A128607E01
  1. Loosen the pulley by turning SST (B) in the direction shown in the illustration.

  1. Remove the generator assembly from the SST.

  1. Remove the clutch pulley from the rotor shaft.



2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A128608
  1. Place the generator assembly on the clutch pulley.



    A128610
  1. Remove the 3 nuts and generator rear end cover.



3. REMOVE GENERATOR TERMINAL INSULATOR


    A128609
  1. Remove the terminal insulator.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A128611
  1. Remove the 2 screws and generator brush holder.



5. REMOVE GENERATOR ROTOR ASSEMBLY


    A128612
  1. Remove the 4 bolts.



    A128613
  1. Remove the bolt and cord clip.



    A128614E01
  1. Using SST, remove the coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A118365E01
  1. Remove the washer.



    A128615
  1. Remove the generator rotor.



7. REMOVE GENERATOR DRIVE END FRAME BEARING


    A128617
  1. Remove the 4 screws and bearing retainer.



    A128618E01
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)