GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, press in a new generator drive end frame bearing.
![]() |
Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.
Install the 4 screws.
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
Place the drive end frame on the clutch pulley.
![]() |
Install the generator rotor onto the generator rectifier end frame.
![]() |
Place a new generator washer on the generator rotor.
| 3. INSTALL GENERATOR COIL ASSEMBLY |
![]() |
Using SST and a press, press in the generator coil assembly to the drive end frame.
![]() |
Tighten the 4 bolts.
![]() |
Install the cord clip with the bolt.
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes into the generator brush holder, insert a 1.0 mm (0.039 in.) pin into the generator brush holder.
![]() |
Install the generator brush holder with the 2 screws.
![]() |
Pull the pin out of the generator brush holder.
| 5. INSTALL GENERATOR TERMINAL INSULATOR |
![]() |
Install the terminal insulator onto the generator rectifier end frame.
| 6. INSTALL GENERATOR REAR END COVER |
![]() |
Install the generator rear end cover with the 3 nuts.
| 7. INSTALL GENERATOR CLUTCH PULLEY |
Temporarily install the clutch pulley onto the rotor shaft.
![]() |
Set SST (A) and (B).
Clamp SST (A) in a vise.
![]() |
Place the rotor shaft end into SST (A).
![]() |
Fit SST (B) to the clutch pulley.
![]() |
Tighten the pulley by turning SST (B) in the direction shown in the illustration.
Remove the generator assembly from the SST.
Check that the clutch pulley rotates smoothly.
Install a new clutch pulley cap to the clutch pulley.