WATER PUMP > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER RH |
| 3. REMOVE ENGINE UNDER COVER LH |
| 4. DRAIN ENGINE COOLANT |
Remove the radiator cap sub-assembly from the radiator assembly.
Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.

| 5. REMOVE FRONT FENDER APRON SEAL RH |
| 6. REMOVE NO. 2 ENGINE MOUNTING STAY RH |
![]() |
Remove the 2 bolts and No. 2 mounting stay RH.
| 7. REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY |
![]() |
Remove the bolt and disconnect the ground cable.
![]() |
Remove the 3 bolts and the engine moving control rod with bracket.
| 8. REMOVE NO. 2 ENGINE MOUNTING BRACKET RH |
![]() |
Remove the 3 bolts and No. 2 mounting bracket RH.
| 9. REMOVE V-RIBBED BELT |
![]() |
Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
| 10. REMOVE GENERATOR ASSEMBLY |
![]() |
Disconnect the generator connector.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and wire harness clamp bracket.
Remove the wire harness clamps.
![]() |
Remove the 2 bolts and generator assembly.
| 11. REMOVE WATER PUMP PULLEY |
![]() |
Using SST, remove the 4 bolts and water pump pulley.
| 12. REMOVE WATER PUMP ASSEMBLY |
![]() |
Remove the clamp of the crankshaft position sensor from the water pump.
Disconnect the wire of the crankshaft position sensor from the clamp bracket.
![]() |
Remove the 4 bolts, 2 nuts and clamp bracket.
![]() |
Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.