Home › ENGINE ยท 2AZ-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH


2. REMOVE ENGINE UNDER COVER RH


3. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Remove the radiator cap sub-assembly from the radiator assembly.



  1. Loosen the radiator drain cock plug and cylinder block drain cock plug, then drain the coolant.


    A136224E04

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



4. DISCONNECT RADIATOR HOSE OUTLET


    A127545
  1. Remove the clamp and disconnect the radiator hose outlet.



5. REMOVE WATER INLET


A112181
  1. Remove the 2 nuts and disconnect the water inlet from the cylinder block.



6. REMOVE THERMOSTAT
  1. Remove the gasket from the thermostat.