DTC B15C2 Speed Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15C2 | A difference between the GPS speed and SPD pulse is detected |
|
| for 2AR-FE |

| for 2GR-FE |

| 1.CHECK VEHICLE SENSOR (OPERATION CHECK) |
![]() |
Enter the "Vehicle Sensors" (Check GPS&Vehicle Sensor) (Click here).
While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.
|
| ||||
| OK | ||
| ||
| 2.INSPECT COMBINATION METER ASSEMBLY (OUTPUT WAVEFORM) |
![]() |
Check the input waveform.
Remove the combination meter assembly with the connector(s) still connected.
Connect an oscilloscope to terminal F2-12 (+S) and body ground.
Turn the ignition switch ON.
Turn the wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Measurement terminal | F2-12 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Driving at approx. 20 km/h (12 mph) |
| *1 | Component without harness connected (Combination Meter Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR |
![]() |
Disconnect the navigation receiver assembly connector.
![]() |
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F25-3 (SPD) - F2-12 (+S) | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *2 | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - JUNCTION CONNECTOR) |
![]() |
Disconnect the navigation receiver assembly connector.
![]() |
Disconnect the junction block connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F2-3 (SPD) - 3U-9 | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *2 | Front view of wire harness connector (to Junction Block) |
|
| ||||
| OK | ||
| ||