Home › BODY ELECTRICAL › METER › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH


  1. Disconnect the steering pad switch connector.


    E128142E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:

    Tester Connection
    Condition
    Specified Condition
    a1- 7 (DISP) - a1-9 (EAU)
    DISP switch is not pushed in.
    10 kΩ or higher
    a1- 7 (DISP) - a1-9 (EAU)
    DISP switch is pushed in.
    Below 1 Ω

    HINT:
    1. This inspection is needed only for 4 spoke model steering pad switch.
    1. If the value is not as specified, replace the steering pad switch.