FORWARD CLUTCH > REASSEMBLY |
| 1. INSTALL INPUT SHAFT OIL SEAL RING |
![]() |
Compress a new input shaft oil seal ring from both sides to adjust dimension A.
Coat the oil seal ring with ATF and install it to the input shaft.
| 2. INSTALL FORWARD CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Coat the forward clutch piston with ATF, and install it to the input shaft.
| 3. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Install the return spring to the input shaft.
Coat the clutch balancer with ATF.
![]() |
Install the clutch balancer to the input shaft.
![]() |
Place SST on the clutch balancer, and compress the clutch balancer with a press.
Install the snap ring with a snap ring expander.
![]() |
Position the end gap of the snap ring in the piston as shown in the illustration.
| 4. INSTALL FORWARD MULTIPLE DISC CLUTCH DISC |
Coat the 5 discs with ATF.
![]() |
Install the 5 plates, 5 discs, and flange to the input shaft.
![]() |
Using a screwdriver, install the snap ring.
Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 5. INSPECT PACK CLEARANCE OF FORWARD CLUTCH |
![]() |
Install the forward clutch on the oil pump.
Using a dial indicator, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| No. | Thickness | No. | Thickness |
| 1 | 3.00 (0.1181) | 4 | 3.45 (0.1358) |
| 2 | 3.15 (0.1240) | 5 | 3.60 (0.1417) |
| 3 | 3.30 (0.1299) | - | - |
| 6. INSPECT FORWARD MULTIPLE CLUTCH DISC |
![]() |
Check if the disc lightly rotates when rotating the forward clutch assembly after inserting the multiple disc clutch into it.