Home › BODY › ENGINE HOOD / DOOR › LUGGAGE DOOR HINGE TORSION BAR

LUGGAGE DOOR HINGE TORSION BAR > INSTALLATION

for Preparation Click here


HINT:
After installing the torsion bar, use your hand to open and close the luggage door. Make sure the luggage door can open and close smoothly.



1. INSTALL LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT


    B136820
  1. Install the luggage compartment door torsion bar support as shown in the illustration.



2. INSTALL LUGGAGE DOOR HINGE TORSION BAR LH


    B136875E01
  1. Set the tip of the luggage door hinge torsion bar LH in the center installation hole. The upper and lower installation holes are used for adjustment.



    B136816
  1. Connect the luggage door hinge torsion bar LH to the right side of the vehicle body as shown in the illustration.



    B136810
  1. Connect the luggage door hinge torsion bar LH to the luggage compartment door torsion bar support as shown in the illustration.



    B136812
  1. Using SST, install the luggage door hinge torsion bar LH to the luggage door hinge and the left side of the vehicle body as shown in the illustration.

    SST
    09804-24010  



3. INSTALL LUGGAGE DOOR HINGE TORSION BAR RH


    B136874E01
  1. Set the tip of the luggage door hinge torsion bar RH in the center installation hole. The upper and lower installation holes are used for adjustment.



    B136818
  1. Connect the luggage door hinge torsion bar RH to the left side of the vehicle body as shown in the illustration.



    B136499
  1. Connect the luggage door hinge torsion bar RH to the luggage compartment door torsion bar support as shown in the illustration.



    B136814
  1. Using SST, install the luggage door hinge torsion bar RH to the luggage door hinge and the right side of the vehicle body as shown in the illustration.

    SST
    09804-24010  



4. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH


    B136854
  1. Install the luggage compartment inner trim cover LH with the 2 clips.



5. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH


    B136855
  1. Install the luggage compartment inner trim cover RH with the 2 clips.



6. INSTALL REAR FLOOR FINISH PLATE


    B136852
  1. Engage the 7 clips and install the rear floor finish plate.



7. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B136879
  1. Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.



8. INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY


    B136853
  1. Engage the clip and install the luggage compartment side tray assembly.

  1. Install the bolt.



9. INSTALL SPARE WHEEL COVER ASSEMBLY


10. INSTALL SPARE WHEEL COVER CLAMP


11. INSTALL LUGGAGE COMPARTMENT FLOOR MAT