Home › BODY ELECTRICAL › LIGHTING › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER


    E074066E03
  1. Apply battery voltage to the transponder key amplifier connector.

  1. Check that the ignition key cylinder light comes on.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2 (ILL+)
    Battery negative (-) → Terminal 6 (ILL-)
    Ignition key cylinder light comes on

    If the result is not as specified, replace the transponder key amplifier.