VANE PUMP (for 2AZ-FE) > INSTALLATION |
| 1. INSTALL VANE PUMP ASSEMBLY |
![]() |
Temporarily install the 2 bolts to the vane pump assembly.
Install the vane pump assembly.
![]() |
Using SST, tighten the 2 bolts.
| 2. CONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR |
![]() |
Connect the connector to the power steering fluid pressure switch.
| 3. CONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD) |
Install a new gasket to the pressure feed tube assembly.
![]() |
Connect the pressure feed tube assembly to the vane pump assembly with the union bolt.
| 4. CONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD) |
Install a new gasket to the pressure feed tube assembly.
![]() |
Connect the pressure feed tube assembly to the vane pump assembly with the union bolt.
| 5. CONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE |
![]() |
Connect the No. 1 fluid reservoir to pump hose to the vane pump assembly with the clip.
| 6. INSTALL FAN & GENERATOR V BELT |
| 7. ADD POWER STEERING FLUID |
| 8. BLEED POWER STEERING FLUID |
Check the fluid level .
Jack up the front of the vehicle and support it with stands.
Turn the steering wheel.
With the engine stopped, turn the steering wheel slowly from lock to lock several times.
Lower the vehicle.
Start the engine.
Run the engine at idle for a few minutes.
Turn the steering wheel.
With the engine idling, turn the steering wheel left or right to the full lock position and keep it in that position for 2 to 3 seconds, then turn the steering wheel to the opposite full lock position and keep it there for 2 to 3 seconds.
Repeat this procedure several times.
Stop the engine.
![]() |
Check for foaming or emulsification.
Check the fluid level .
| 9. CHECK POWER STEERING FLUID LEVEL |
Keep the vehicle level.
![]() |
With the engine stopped, check the fluid level in the fluid reservoir.
If necessary, add fluid.
Start the engine and run it at idle.
Turn the steering wheel from lock to lock several times to raise fluid temperature.
![]() |
Check for foaming or emulsification.
If foaming or emulsification is identified, bleed the power steering system (Click here).
![]() |
With the engine idling, measure the fluid level in the fluid reservoir.
Stop the engine.
Wait a few minutes and remeasure the fluid level in the fluid reservoir.
Check the fluid level.
| 10. CHECK FOR POWER STEERING FLUID LEAKS |