Home › STEERING › POWER STEERING › VANE PUMP (for 2AZ-FE)

VANE PUMP (for 2AZ-FE) > REMOVAL

for Preparation Click here



1. DRAIN POWER STEERING FLUID


2. REMOVE FAN & GENERATOR V BELT

HINT:
Refer to the instructions for removal of the drive belt (Click here).



3. DISCONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE


    C135224E02
  1. Slide the clip and disconnect the No. 1 fluid reservoir to pump hose from the vane pump assembly.



4. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD)


    C135226
  1. Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the gasket from the pressure feed tube assembly.



5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD)


    C137088
  1. Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the gasket from the pressure feed tube assembly.



6. DISCONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR


    C135234
  1. Disconnect the power steering fluid pressure switch connector.



7. REMOVE VANE PUMP ASSEMBLY


    C135228E01
  1. Using SST, loosen the 2 bolts and remove the vane pump assembly.

    SST
    09249-63010  



    C135233
  1. Remove the 2 bolts from the vane pump assembly.