Home › STEERING › POWER STEERING › VANE PUMP (for 2GR-FE)

VANE PUMP (for 2GR-FE) > REMOVAL

for Preparation Click here



1. DRAIN POWER STEERING FLUID


2. REMOVE FAN & GENERATOR V BELT

HINT:
Refer to the instructions for removal of the drive belt (Click here).



3. DISCONNECT NO. 1 FLUID RESERVOIR TO PUMP HOSE


    C133174E02
  1. Slide the clip and disconnect the No. 1 fluid reservoir to pump hose from the vane pump assembly.



4. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for LHD)


    C133175
  1. Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the bolt and separate the pressure feed tube clamp.

  1. Remove the gasket from the pressure feed tube assembly.



5. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (for RHD)


    C137089
  1. Remove the union bolt and disconnect the pressure feed tube assembly from the vane pump assembly.

  1. Remove the gasket from the pressure feed tube assembly.



6. DISCONNECT POWER STEERING FLUID PRESSURE SWITCH CONNECTOR


    C133176
  1. Disconnect the power steering fluid pressure switch connector.



7. REMOVE VANE PUMP ASSEMBLY


    C133177E01
  1. Using SST, loosen bolt (A) and remove bolt (B), and then remove the vane pump assembly.

    SST
    09249-63010  



    C135238
  1. Remove the bolt from the vane pump assembly.