CAMSHAFT > INSPECTION |
| 1. INSPECT CAMSHAFT TIMING GEAR ASSEMBLY |
![]() |
Check the lock of the camshaft timing gear.
Clamp the camshaft in a vise, and confirm that the camshaft timing gear is locked.
Release the lock pin.
Cover the 4 oil paths of the cam journal with vinyl tape as shown in the illustration.
Break through the tape of the advance side path and the retard side path on the opposite side to the hole of the advance side path, as shown in the illustration.
![]() |
Apply approximately 200 kPa (2.0 kgf/cm2, 28 psi) of air pressure to the two broken paths.
Check that the camshaft timing gear revolves in the advance direction when reducing the air pressure of the retard side path.
When the camshaft timing gear reaches the most advanced position, remove the air gun from the retard side path and advance side path, in that order.
Check for smooth rotation.
Rotate the camshaft timing gear within its movable range several times, but do not turn it to the most retarded position. Check that the gear rotates smoothly.
Check the lock in the most retarded position.
Confirm that the camshaft timing gear is locked at the most retarded position.
| 2. INSPECT CAMSHAFT |
![]() |
Inspect the camshaft for runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
![]() |
Inspect the cam lobes.
Using a micrometer, measure the cam lobe height.
![]() |
Inspect the camshaft journals.
Using a micrometer, measure the journal diameter.
| Journal Position | Specified Condition |
| No. 1 | 35.971 to 35.985 mm (1.4162 to 1.4167 in.) |
| Other | 22.959 to 22.975 mm (0.9039 to 0.9045 in.) |
| 3. INSPECT NO. 2 CAMSHAFT |
![]() |
Inspect the camshaft for runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
![]() |
Inspect the cam lobes.
Using a micrometer, measure the cam lobe height.
![]() |
Inspect the camshaft journals.
Using a micrometer, measure the journal diameter.
| Journal Position | Specified Condition |
| No. 1 | 35.971 to 35.985 mm (1.4162 to 1.4167 in.) |
| Other | 22.959 to 22.975 mm (0.9039 to 0.9045 in.) |