SFI SYSTEM > VC Output Circuit |


| 1.CHECK MIL CONDITION |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch to the ON position.
|
| ||||
| OK | ||
| ||
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Check for communication between the tester and ECM.
| Result | Proceed to |
| Communication is possible | A |
| Communication is not possible | B |
|
| ||||
| B | |
| 3.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the C5 throttle body connector.
Turn the ignition switch to the ON position.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the throttle body connector.
|
| ||||
| B | |
| 4.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the A17 accelerator pedal position sensor connector.
Turn the ignition switch to the ON position.
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the accelerator pedal position sensor connector.
|
| ||||
| B | |
| 5.CHECK HARNESS AND CONNECTOR |
Disconnect the C5 throttle body connector.
Disconnect the A17 accelerator pedal position sensor connector.
![]() |
Disconnect the A24 and C24 ECM connectors.
Measure the resistance between the terminals of the wire harness side connectors.
| Tester Connection | Specified Condition |
| VCTA (C24-67) - Body ground | 10 kΩ or higher |
| VCPA (A24-57) - Body ground | |
| VCP2 (A24-58) - Body ground |
Reconnect the throttle body connector.
Reconnect the accelerator pedal position sensor connector.
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||