CAN COMMUNICATION SYSTEM (for RHD) > Combination Meter ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Combination Meter ECU Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (COMBINATION METER MAIN BUS WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the combination meter ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-17 (CANH) - F1-18 (CANL) | Ignition switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ES, IG+, B2) |
Disconnect the combination meter connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-24 (ES) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-13 (IG+) - Body ground | Ignition switch on | 10 to 14 V |
| F1-2 (B2) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | ||
| ||