CAN COMMUNICATION SYSTEM (for LHD) > Air Conditioning Amplifier Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Air Conditioning Amplifier Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E38-11 (CANH) - E38-12 (CANL) | Ignition Switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG+, B, GND) |
![]() |
Disconnect the air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E38-14 (GND) - Body Ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E38-1 (IG+) - Body Ground | Ignition Switch on | 10 to 14 V |
| E38-21 (B) - Body Ground | Always | 10 to 14 V |
|
| ||||
| OK | ||
| ||