CAN COMMUNICATION SYSTEM (for LHD) > Main Body ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Main Body ECU Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-5 (CANH) - E8-6 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BECU, IG, GND1) |
![]() |
Disconnect the 1F J/B connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1F-10 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1F-1 (BECU) - Body ground | Always | 10 to 14 V |
| 1F-11 (IG) - Body ground | Ignition switch on | 10 to 14 V |
Reconnect the main body ECU connectors.
|
| ||||
| OK | ||
| ||