SLIDING ROOF HOUSING > DISASSEMBLY |
| 1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
![]() |
Disengage the claw and remove the sliding roof drive gear bracket.
![]() |
Remove the 2 bolts and sliding roof drive gear sub-assembly.
| 2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY |
![]() |
Remove the screw and sliding roof piece sub-assembly LH.
![]() |
Slide and remove the sunshade trim sub-assembly.
| 3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
![]() |
Remove the 2 screws and sliding roof side stoppers.
![]() |
Using a screwdriver, disengage the 2 claws. Then slide the sliding roof drip channel rearward to remove it.
Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.
