Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM


B139181E01


B139182E01


B139203E01


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY)


    B128337E02
  1. Disconnect the E15 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E15-1 (+B) - Body ground
    Always
    10 to 14 V
    E15-2 (IG) - Body ground
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BODY GROUND)


    B128337E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-16 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE