Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

This circuit is used to read the DTCs that are output from the transponder key ECU assembly with the intelligent tester.

WIRING DIAGRAM


B128329E01


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.

1.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - DLC3)


    B128341E01
  1. Disconnect the E15 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-9 (D) - E10-7 (SIL)
    Always
    Below 1 Ω
    E15-9 (D) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    B124215E08
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE