DTC B2796 No Communication in Immobiliser System |
DTC B2798 Communication Malfunction No. 2 |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2796 | The key code cannot be transmitted |
|
| B2798 | Key code identification cannot be completed within the specified time |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester on.
Select Immobiliser in the DATA LIST and read the value displayed on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Immobiliser | Immobiliser system status/SET or UNSET | UNSET: Ignition switch ON SET: Without key | - |
|
| ||||
| NG | |
| 2.CHECK KEYS |
Insert the vehicle's other key into the ignition key cylinder.
Check that the engine starts with this key.
|
| ||||
| NG | |
| 3.REPLACE TRANSPONDER KEY AMPLIFIER |
After replacing the transponder key amplifier (Click here) with a normally functioning amplifier, check that the engine starts.
|
| ||||
| OK | ||
| ||