Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B2797    Communication Malfunction No. 1

for Preparation Click here


DESCRIPTION

This DTC is output when an error occurs in communication between the transponder key amplifier and the transponder key ECU.

HINT:
Some noise is found in the communication line.


DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurred in communication line
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM


B052550E15


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.

1.CHECK KEYS


    B072873E02
  1. Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip.
    A
    Key is not near other keys and/or key ring is not in contact with key grip.
    B



B
Go to step 3
A


2.CHECK DTC OUTPUT
  1. Separate the keys from each other, or remove the key ring.

  1. Delete the DTCs (Click here).

  1. Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.

    OK:
    No code is output.



OK
END
NG


3.CHECK TRANSPONDER KEY AMPLIFIER
  1. After replacing the transponder key amplifier (Click here) with a normally functioning amplifier, check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

END