Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

When an additional transponder key is registered, the transponder key ECU assembly detects the front door courtesy light switch open/close condition, and enters the key registration mode.

WIRING DIAGRAM


B128328E03


B128328E04


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.

1.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH CIRCUIT)


    B128337E01
  1. Disconnect the E15 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-7 (CTY) - Body ground
    Courtesy switch pushed
    (Door closed)
    10 kΩ or higher
    Courtesy switch free
    (Door open)
    Below 1 Ω



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


    B111600E02
  1. Remove the driver side front door courtesy light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Switch body
    Courtesy switch pushed
    (Door closed)
    10 kΩ or higher
    Courtesy switch free
    (Door open)
    Below 1 Ω



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (TRANSPONDER KEY ECU - FRONT DOOR COURTESY LIGHT SWITCH)