DTC B2780 Push Switch / Key Unlock Warning Switch Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2780 | "Unlock warning switch ON" is not detected when ignition switch is ON |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select Key SW in the DATA LIST and read the value displayed on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal/ON or OFF | OFF: Key is in ignition key cylinder ON: No key is in ignition key cylinder | - |
|
| ||||
| NG | |
| 2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 - 2 | Switch pushed (Key set) | Below 1 Ω |
| Switch free (Key removed) | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E22-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH) |
![]() |
Disconnect the E15 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E15-3 (KSW) - E22-1 | Always | Below 1 Ω |
| E22-1 - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||