Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B2793    Transponder Chip Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if the key code registration is not performed normally and this DTC is detected.

DTC No.
DTC Detection Condition
Trouble Area
B2793
Transponder chip malfunction
Key

INSPECTION PROCEDURE

NOTICE:
If the key is replaced, register the key.

1.RE-REGISTER KEY
  1. Delete the DTCs (Click here).

  1. Re-register the key and insert this key into the ignition key cylinder. Check that the engine starts with this key.

    OK:
    The engine starts.



NG
REPLACE KEY
OK

END