Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > Security Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the transponder key is registered, the transponder key ECU assembly outputs the key registration condition by lighting up, blinking or turning off the security indicator.

WIRING DIAGRAM


B128327E01


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester (with CAN VIM) to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Perform the ACTIVE TEST according to the display on the tester.

    IMMOBILISER: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indic
    Turn security indicator
    ON/OFF
    -

    OK:
    Security indicator turns on and off.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT)


    B128342E01
  1. Disconnect the E15 ECU and F3 combination meter connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E15-8 (IND) - F3-8 (LP)
    Always
    Below 1 Ω
    E15-8 (IND) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND)


    B128343E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-19 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT TRANSPONDER KEY ECU ASSEMBLY


    B128338E03
  1. Reconnect the E15 ECU and F3 combination meter connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E15-8 (IND) - Body ground
    Immobiliser set state
    (No key is in ignition key cylinder)
    Repeats 10 to 14 V and below 1 V



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

REPLACE CLOCK ASSEMBLY