ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON or OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - CLOCK ASSEMBLY) |
Disconnect the certification ECU (smart key ECU assembly) connector.
![]() |
Disconnect the clock assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E74-2 (IND) - F3-8 (LP) | Always | Below 1 Ω |
| E74-2 (IND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F3-19 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||