ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
The certification ECU (smart key ECU assembly) and ECM control the vehicle engine immobiliser system functions. Engine immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3).
In some cases, a malfunction may be occurring in the engine immobiliser system even though the security indicator light is not illuminated.
When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
| CHECK DLC3 |
![]() |
The vehicle ECU uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 9 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Engine switch off* | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Engine switch off* | 6 kΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Engine switch off* | 200 Ω or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Engine switch off* | 6 kΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Engine switch off* | 200 Ω or higher |
| INSPECT BATTERY VOLTAGE |
Measure the battery voltage.