Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › PLASMACLUSTER

PLASMACLUSTER > INSTALLATION

for Preparation Click here



1. INSTALL PLASMACLUSTER


    E128542
  1. Install the plasma cluster with the 2 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL NO. 1 HEATER TO REGISTER DUCT


    B134019E02
  1. Install the No. 1 heater to register duct with the 3 screws <F>.



3. INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT


    B134016E02
  1. Install the side No. 1 defroster nozzle duct with the screw <F>.



4. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
  1. Install the instrument panel safety pad assembly (Click here).



5. CONNECT NEGATIVE BATTERY TERMINAL


6. INSPECT STEERING PAD


    C141754
  1. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

    1. Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.

  1. Make sure that the horn sounds.

    HINT:
    If the horn does not sound, inspect the horn system (Click here).



7. INSPECT SRS WARNING LIGHT
(Click here)