Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    E128523
  1. Release the 2 claws and remove the No. 2 air duct sub-assembly as shown in the illustration.



2. REMOVE BLOWER ASSEMBLY


    E128524
  1. Disconnect the connector.

  1. Remove the 2 screws and blower assembly.



3. REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY


    E128525
  1. Release the 4 claws and remove the No. 6 heater to register duct assembly.



4. REMOVE DRAIN COOLER HOSE


    E128535
  1. Remove the drain cooler hose from the air conditioning radiator assembly.



5. REMOVE AIR OUTLET CONTROL SERVO MOTOR


    E128526
  1. Disconnect the 2 connectors and remove the air conditioner harness.

  1. Remove the 3 screws and then remove the air outlet control servo motor.



6. REMOVE AIR MIX CONTROL SERVO MOTOR


    C129729
  1. Remove the 2 screws and air mix control servo motor.



7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY


    C129730
  1. Remove the screw and clamp.

  1. Release the 4 claws and remove the clamp.



    E128528
  1. Remove the heater radiator unit sub-assembly from the air conditioning radiator assembly.

    NOTICE:
    Prepare a drain pan or cloth in case the cooling water leaks.



8. REMOVE COOLER EXPANSION VALVE


    C129879
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.



9. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E128529
  1. Remove the 6 screws, release the 4 claws, and remove the plate cover.



    C129878E02
  1. Remove the clamp and No. 1 cooler thermistor.



    C129880
  1. Remove the No. 1 cooler evaporator sub-assembly.



    C129881
  1. Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.