Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Door Key Lock / Unlock Switch Circuit

for Preparation Click here


DESCRIPTION

The door lock and unlock switch is built into the front passenger door lock assembly.
This switch is ON when the door key is in the unlock position and OFF when the door key is in the lock position. It is used as one of the operating conditions for the key confinement prevention function.

WIRING DIAGRAM


B109774E09


B109774E10


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR LOCK ASSEMBLY RH (DOOR KEY LOCK AND UNLOCK SWITCH)


    B112613E03
  1. Inspect LHD models.

    1. Remove the front door lock assembly RH.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      5 - 8
      ON
      (Door lock set to UNLOCK)
      Below 1 Ω
      5 - 8
      6 - 8
      OFF (Free)
      10 kΩ or higher
      6 - 8
      ON
      (Door lock set to LOCK)
      Below 1 Ω



    B065428E09
  1. Inspect RHD models.

    1. Remove the front door lock assembly LH.

    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      7 - 9
      ON (Door lock set to LOCK)
      Below 1 Ω
      7 - 9
      7 - 10
      OFF (Free)
      10 kΩ or higher
      7 - 10
      ON (Door lock set to UNLOCK)
      Below 1 Ω



NG
REPLACE FRONT DOOR LOCK ASSEMBLY LH
OK


2.CHECK WIRE HARNESS (FRONT DOOR LOCK RH - MAIN BODY ECU (INSTRUMENT PANEL J/B))


  1. Disconnect the IJ J/B connector.


    B138032E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    (*1) M8-6 (L) - IJ-5
    Always
    Below 1 Ω
    (*1) M8-5 (UL) - IK-7
    Always
    Below 1 Ω
    (*1) M8-8 (E) - Body ground
    Always
    Below 1 Ω
    (*1) M8-6 (L) - Body ground
    Always
    10 kΩ or higher
    (*1) M8-5 (UL) - Body ground
    Always
    10 kΩ or higher
    (*2) I7-9 (L) - IK-16
    Always
    Below 1 Ω
    (*2) I7-10 (UL) - IJ-7
    Always
    Below 1 Ω
    (*2) I7-7 (E) - Body ground
    Always
    Below 1 Ω
    (*2) I7-9 (L) - Body ground
    Always
    10 kΩ or higher
    (*2) I7-10 (UL) - Body ground
    Always
    10 kΩ or higher

    *1: LHD
    *2: RHD



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE