Home › ENGINE ยท 2GR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT


2. REMOVE V-BANK COVER SUB-ASSEMBLY


    A132968
  1. Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



3. REMOVE FRONT FENDER APRON SEAL RH


4. REMOVE NO. 2 ENGINE MOUNTING STAY RH


    A132985
  1. Remove the bolt, 2 nuts, and No. 2 mounting stay RH.



5. REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY


    A132986
  1. Remove the 4 bolts and engine moving control rod.



6. REMOVE V-RIBBED BELT


    A129622E01
  1. Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

    SST
    09249-63010  



    A095070
  1. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.



7. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A129645E01
  1. Remove the bolt, plate and No. 2 idler pulley sub-assembly.



8. DISCONNECT RADIATOR HOSE OUTLET


    A133364
  1. Separate the radiator outlet hose from the radiator assembly.



9. REMOVE WATER INLET


    A133374
  1. Remove the 2 nuts and water inlet.



10. REMOVE THERMOSTAT
  1. Remove the gasket from the thermostat.