RADIATOR > REASSEMBLY |
| 1. INSTALL RADIATOR TANK UPPER |
![]() |
Install the punch assembly to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.
![]() |
After checking that there are no foreign objects in the lock plate groove, install a new O-ring without twisting it.
![]() |
Install the tank without damaging the O-ring.
Tap the lock plate with a soft-faced hammer so that there is no gap between the lock plate and the tank.
![]() |
Lightly press SST against the lock plate in the order shown in the illustration. After repeating this a few times, fully caulk the lock plate by gripping the handle until stopped by the stopper plate.
![]() |
Check the lock plate height (H) after completing caulking.
| 2. INSTALL RADIATOR TANK LOWER |
| 3. INSTALL DRAIN PLUG |
Install a new O-ring to the drain plug.
Install the drain plug.
| 4. INSPECT FOR WATER LEAKS |
![]() |
Plug the inlet and outlet pipes of the radiator with SST.
Using the radiator cap tester, apply pressure to the radiator.
Submerge the radiator in water.
![]() |
Inspect for leaks.