Home › ENGINE ยท 2GR-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill above the full level mark.



2. CHECK ENGINE OIL QUALITY


    A113813E01
  1. Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the oil.

    Oil grade:
    20W-50 and 15W-40:
    API grade SL or SM multigrade engine oil
    10W-30 and 5W-30:
    API grade SL Energy-Conserving, SM Energy-Conserving or ILSAC multigrade engine oil



3. CHECK OIL PRESSURE
  1. Remove the engine under cover LH.

  1. Remove the engine under cover RH.

  1. Disconnect the oil pressure switch connector.



    A127994
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



    A127995
  1. Install the oil pressure gauge with adapter.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard oil pressure:
    Engine Condition
    Oil Pressure
    Idle
    80 kPa (0.8 kgf*cm2, 11.6 psi) or more
    6,000 rpm
    380 kPa (3.9 kgf*cm2, 55.5 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here).



    A050082E14
  1. Remove the oil pressure gauge.

  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A127994
  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine within 1 hour after installation.

  1. Connect the oil pressure switch connector.

  1. Check for engine oil leaks.

  1. Remove the engine under cover RH.

  1. Remove the engine under cover LH.