IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT IGNITION COIL ASSEMBLY |
Check for DTCs.
Check that sparks occur.
Remove the intake air surge tank (Click here).
Remove the No. 1 surge tank stay .
![]() |
Disconnect the 6 ignition coil connectors and remove the 6 bolts and 6 ignition coils.
![]() |
Using a 16 mm (0.63 in.) plug wrench, remove the 6 spark plugs.
![]() |
Disconnect the 6 fuel injector connectors.
Install the spark plugs to each ignition coil, and connect the ignition coil connectors.
![]() |
Ground the spark plugs.
Check if a spark occurs at each spark plug while the engine is being cranked.
Perform the spark test according to the flowchart below.
Check that the ignition coil connector is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform a speak test on each ignition coil.
| Result | Proceed to |
| OK | Replace ignition coil |
| NG | Go to next step |
Check the power supply to the ignition coil.
| Result | Proceed to |
| NG | Check wiring between ignition switch and ignition coil |
| OK | Go to next step |
Check the VVT sensor output voltage.
| Result | Proceed to |
| NG | Check that there is resistance between ECM and VVT sensor. If there is no resistance, replace VVT sensor. If there is resistance, repair wiring between VVT sensor and ECM. |
| OK | Go to next step |
Measure the resistance of the crankshaft position sensor.
| Temperature | Specified Condition |
| Cold | 1,630 to 2,740 Ω |
| Hot | 2,065 to 3,225 Ω |
| Result | Proceed to |
| NG | Replace crankshaft position sensor |
| OK | Go to next step |
Check the IGT signal from the ECM.
| Result | Proceed to |
| NG | Check ECM (Click here) |
| OK | Repair wiring between ignition coil and ECM |
Using a 16 mm (0.63 in.) plug wrench, install the spark plugs.
Install the 6 ignition coils with the 6 bolts and connect the 6 ignition coil connectors.
Connect the 6 fuel injector connectors.
Install the No. 1 surge tank stay .
Install the intake air surge tank (Click here).
| 2. INSPECT SPARK PLUG |
![]() |
Check the electrode.
Using a megohmmeter, measure the insulation resistance.
Alternative inspection method:
Quickly accelerate the engine to 4,000 rpm 5 times.
Remove the spark plugs.
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its threads and insulator. If there is damage, replace the spark plug.
| Manufacturer | Spark plug type |
| DENSO made | FK20HR11 |
![]() |
Check the spark plug electrode gap.
![]() |
Clean the spark plugs.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry it.