FUEL INJECTOR > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
Inspect injector resistance.
Using an ohmmeter, measure the resistance between the terminals.
Inspect the injection volume.
![]() |
Install the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (vehicle side).
Install the O-ring to the fuel injector.
![]() |
Connect SST (adaptor and hose) to the injector, and hold the injector and union with SST (clamp).
Put the injector into the graduated cylinder.
Operate the fuel pump .
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
![]() |
Check for leakage.
In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector.