Home › ENGINE ยท 2GR-FE › FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 2 FUEL SUCTION SUPPORT


    A077832E05
  1. Using a screwdriver with its tip wrapped with tape, disengage the 5 snap claws from the claw holes, and remove the No. 2 fuel suction support.

    NOTICE:
    Do not damage the fuel suction support.



2. REMOVE FUEL PUMP CUSHION RUBBER


    A079492E01
  1. Remove the fuel pump cushion rubber from the fuel pump.



3. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A129482E02
  1. Disconnect the fuel sender gauge connector (*1).

  1. Unlock the fuel sender gauge, and slide it to remove (*2).



4. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    A129483E02
  1. Disconnect the fuel pump connector (*1).

  1. Using a screwdriver with its tip wrapped with tape, disengage the 4 snap claws from the claw holes, and pull out the fuel suction plate.

    NOTICE:
    Do not damage the fuel suction support.



5. REMOVE FUEL PUMP HARNESS


    A079495E05
  1. Disconnect the connector (*1).

  1. Using a screwdriver, pry out the fuel pump harness (*2).



6. REMOVE FUEL PUMP


    A079496E01
  1. Pull out the fuel pump from the fuel filter.



7. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A133536E01
  1. Pull out the fuel pressure regulator from the fuel filter.



    A133534E02
  1. Remove the O-ring from the fuel pressure regulator.