Home › ENGINE ยท 2GR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET


    A060823E05
  1. Install the rear support bracket with the 2 bolts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Be sure to install the bracket in the correct direction.



2. INSTALL HEATED OXYGEN SENSOR (for Bank 2)


    A135725E01
  1. Using SST, install the heated oxygen sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }



3. INSTALL HEATED OXYGEN SENSOR


    A135717E01
  1. Using SST, install the heated oxygen sensor.

    SST
    09224-00010  



4. INSTALL EXHAUST FRONT PIPE ASSEMBLY
  1. Install 2 new gaskets to the exhaust front pipe.



  1. Install the exhaust front pipe to the exhaust manifolds with the 4 nuts.


    A135720

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }



5. INSTALL FRONT EXHAUST PIPE NO. 1 SUPPORT BRACKET


    A085549E01
  1. Install the front support brackets with the 2 nuts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Be sure to install the support brackets in the correct direction.



6. INSTALL EXHAUST CENTER PIPE ASSEMBLY
  1. Install a new gasket to the exhaust center pipe assembly.



  1. Install the exhaust center pipe to the exhaust front pipe with the 2 nuts and 2 bolts.


    A135719

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }



7. INSTALL EXHAUST TAIL PIPE ASSEMBLY
  1. Install 2 new gaskets to the exhaust tail pipes.



  1. Install the 2 exhaust tail pipes with the 4 nuts.


    A135718

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



8. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.