INTAKE AIR CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT INTAKE AIR CONTROL VALVE ASSEMBLY |
Inspection procedure when using the intelligent tester:
Warm up the engine.
Stop the engine.
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the following menu items: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / INTAKE CTL VSV1. Press the right or left button.
![]() |
Make sure that a clicking sound is heard from the intake air control valve when current flows.
If the result is not as specified, replace the intake air surge tank.