Home › ENGINE · 2GR-FE › INTAKE › VACUUM SWITCHING VALVE

VACUUM SWITCHING VALVE > INSPECTION

for Preparation Click here



1. INSPECT VACUUM SWITCHING VALVE


    A085570E04
  1. Measure the VSV resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    1-2
    37 to 44 Ω at 20°C (68°F)
    1 - Body ground
    2 - Body ground
    10 kΩ or higher

    If the result is not as specified, replace the VSV.



  1. Check VSV operation.



      A128950E01
    1. When vacuum is applied to the E port, check that air is sucked into the filter.
      If the result is not as specified, replace the VSV.



    2. A128951E01
    3. Apply battery voltage across the terminals. When vacuum is applied to the F port, check that air is sucked into the E port.
      If the result is not as specified, replace the VSV.